Best Heat Pump Replacement Companies in Frankfort, KY
Heat Pump Replacement in Frankfort: sizing + authorization
A replacement or conversion is bid on Manual J load calculation, manufacturer authorization, and matched-system commissioning — oversizing is the #1 cause of comfort complaints. Here is what each of the 1 contractor below publishes: Verify your state's HVAC contractor license through the state licensing board before paying a deposit.
Top picks
Consistently strong customer feedback (4.9★ from 440+ Google reviews).
Google 4.9★ (440+)
Typical Heat Pump Replacement costs in Frankfort, KY (2026)
Last updated
Estimated ranges for Frankfort, KY. Actual cost varies with home size, equipment, and scope — always request a written quote for your job.
| Service | Typical range |
|---|---|
| Ducted air-source heat pump + air handler, full system (installed) | $6,950–$13,950 |
| Air handler replacement (paired with heat pump) | $1,300–$3,050 |
| Ductwork modification (resize / re-balance per Manual D) | $525–$1,900 |
How long will a Heat Pump Installation take in Frankfort, and what local rules matter?
- Can I replace my gas furnace with a heat pump?
- Yes — a heat pump both heats and cools, so it can fully replace a gas furnace. In colder areas a dual-fuel setup keeps the furnace as backup for the coldest days. Either way, insist on a Manual J load calculation; conversions can need duct resizing or an electrical upgrade.
- When is replacing an old heat pump better than repairing it?
- If it's past 12–15 years, still uses phased-out R-410A refrigerant, needs a compressor, or the repair bill approaches a third of replacement cost, replacing usually wins. A reputable contractor compares both paths before recommending.
- Do Frankfort installers need a DHBC HVAC license to perform heat pump replacements?
- Yes. Contractors performing heat pump replacements must be licensed through the Kentucky DHBC Division of HVAC. Permit and license checks occur during plan review and at inspection. Homeowners should confirm a contractor's DHBC license number before signing a contract and request documentation that permits will be pulled under that license.
- Are code-based load calculations required for heat pump replacements in Frankfort?
- Yes. Load calculations based on the 2021 IECC are required to size equipment correctly. Inspectors expect documentation showing compliance. Proper sizing avoids undersized systems that struggle in Frankfort's winter chill and reduces the risk of failed inspections.
- How do I find a cold-climate heat pump specialist in Frankfort?
- Look for installers who advertise cold-climate sizing experience and who reference cold-weather performance in proposals. Check for DHBC licensing, documented load calculations, manufacturer certification for cold-climate models, and reviews that mention winter performance. Request past project references for similar Frankfort homes.
- How do I get a quote from these heat pump installation companies?
- Submit one request on this page and we send it to the vetted heat pump installation pros in Frankfort, KY listed here. They send quotes back — no obligation.