Best Heat Pump Replacement Companies in Kent, WA
Heat Pump Replacement in Kent: sizing + authorization
A replacement or conversion is bid on Manual J load calculation, manufacturer authorization, and matched-system commissioning — oversizing is the #1 cause of comfort complaints. Here is what each of the 3 contractors below publishes: In Washington, HVAC contractors hold an L&I HVAC/R Specialty Contractor license — verify on lni.wa.gov before scheduling.
Top picks
Consistently strong customer feedback (4.8★ from 1,075+ Google reviews).
Google 4.8★ (1,075+)
Consistently strong customer feedback (4.7★ from 1,540+ Google reviews).
Google 4.7★ (1,540+)
Consistently strong customer feedback (4.9★ from 65+ Google reviews).
Google 4.9★ (65+)
Typical Heat Pump Replacement costs in Kent, WA (2026)
Last updated
Estimated ranges for Kent, WA. Actual cost varies with home size, equipment, and scope — always request a written quote for your job.
| Service | Typical range |
|---|---|
| Ducted air-source heat pump + air handler, full system (installed) | $9,600–$19,200 |
| Air handler replacement (paired with heat pump) | $1,800–$4,200 |
| Ductwork modification (resize / re-balance per Manual D) | $720–$2,650 |
Why Kent homeowners call for Heat Pump Installation after wet winters and mild summers
Persistent damp, mild summers, and seasonal demand for efficient heating and cooling push many homeowners toward heat pump upgrades in Kent, WA. For local projects, searching for best heat pump installation companies in Kent, Washington helps locate contractors familiar with wet-climate sealing and crawlspace moisture control. It also surfaces firms experienced with Kent permitting and retrofit code requirements.
How long do Heat Pump Installation warranties and same-day services actually run in Kent?
- Can I replace my gas furnace with a heat pump?
- Yes — a heat pump both heats and cools, so it can fully replace a gas furnace. In colder areas a dual-fuel setup keeps the furnace as backup for the coldest days. Either way, insist on a Manual J load calculation; conversions can need duct resizing or an electrical upgrade.
- When is replacing an old heat pump better than repairing it?
- If it's past 12–15 years, still uses phased-out R-410A refrigerant, needs a compressor, or the repair bill approaches a third of replacement cost, replacing usually wins. A reputable contractor compares both paths before recommending.
- When is the busiest season for heat pump replacement in Kent and how does it affect lead times?
- Kent installers are busiest in late fall and early winter when homeowners and businesses shift from cooling to heating. Lead times lengthen during these peak months, and same-day replacement options become scarcer. Schedule replacements before seasonal demand spikes to avoid longer waits. Request a documented install date and contingency plan for emergency failures.
- How do warranty lengths and vendor warranties usually work for heat pump replacements in Kent?
- Manufacturer and installer warranties commonly run separate terms; manufacturers cover equipment and installers cover labor and workmanship (advertised). Homeowners should get both warranty documents in writing and note any registration steps. Verify whether warranties require annual maintenance and which party handles warranty service calls.
- How can Kent homeowners verify an installer's experience with inverter and cold-climate heat pumps?
- Request past job photos, model numbers used, and customer references for inverter or cold-climate installs. Look for documentation of Manual J sizing and AHRI match for the specific models installed. Also check installer training records or manufacturer-dealer status. These signals show practical experience without relying on review counts alone.
- How do I get a quote from these heat pump installation companies?
- Submit one request on this page and we send it to the vetted heat pump installation pros in Kent, WA listed here. They send quotes back — no obligation.