Can I replace my gas furnace with a heat pump?

Yes — a heat pump both heats and cools, so it can fully replace a gas furnace. In colder areas a dual-fuel setup keeps the furnace as backup for the coldest days. Either way, insist on a Manual J load calculation; conversions can need duct resizing or an electrical upgrade.

When is replacing an old heat pump better than repairing it?

If it's past 12–15 years, still uses phased-out R-410A refrigerant, needs a compressor, or the repair bill approaches a third of replacement cost, replacing usually wins. A reputable contractor compares both paths before recommending.

How to tell when a Madison heat pump should be replaced rather than repaired?

Replace when repeated failures, frequent refrigerant leaks, or poor efficiency persist despite repairs. Older units subject to freeze-thaw damage often cost more to maintain. Request an inspection report comparing repair costs, remaining lifespan, and expected performance improvements.

Do Madison permits and inspections commonly delay final system commissioning?

They can. Permit approval and municipal inspections sometimes add days to completion, especially during busy seasons. Use a licensed, bonded installer who handles permits to minimize administrative delays and coordinate final commissioning with the city inspector.

Is dual-fuel integration common for Madison homes with existing gas furnaces?

Dual-fuel setups are available and useful when a backup gas furnace is desired for extreme cold. Look for installers who can program seamless switching between heat pump and furnace and who provide control strategies tailored to Madison's temperature swings.

How do I get a quote from these heat pump installation companies?

Submit one request on this page and we send it to the vetted heat pump installation pros in Madison, WI listed here. They send quotes back — no obligation.

Best Heat Pump Replacement Companies in Madison, WI

Last updated July 26, 2026

Heat Pump Replacement in Madison: sizing + authorization

A replacement or conversion is bid on Manual J load calculation, manufacturer authorization, and matched-system commissioning — oversizing is the #1 cause of comfort complaints. Here is what each of the 1 contractor below publishes: In Wisconsin, HVAC contractors hold a DSPS HVAC Contractor credential — verify on dsps.wi.gov before scheduling.

How we rank Heat Pump Replacement providers → · Top picks meet at least one of: a category award, ≥2 verified signals, or Vouched Score ≥ 70.

Top picks

All Comfort Services
Consistently strong customer feedback (4.8★ from 3,625+ Google reviews).
Google 4.8★ (3,625+)

Typical Heat Pump Replacement costs in Madison, WI (2026)

Last updated June 19, 2026

Estimated ranges for Madison, WI. Actual cost varies with home size, equipment, and scope — always request a written quote for your job.

Service	Typical range
Ducted air-source heat pump + air handler, full system (installed)	$7,900–$15,800
Air handler replacement (paired with heat pump)	$1,500–$3,450
Ductwork modification (resize / re-balance per Manual D)	$590–$2,150

Why Madison homeowners choose professional Heat Pump Installation as winters and summers shift

Madison, WI homeowners face seasonal swings that change heating and cooling needs, so choosing the best heat pump installation companies in Madison, Wisconsin matters for year-round comfort. Demand patterns vary with the local climate, so schedule early and confirm installer availability before peak seasons.

How long does a typical Heat Pump Installation take in Madison, and what can delay it?

Can I replace my gas furnace with a heat pump?: Yes — a heat pump both heats and cools, so it can fully replace a gas furnace. In colder areas a dual-fuel setup keeps the furnace as backup for the coldest days. Either way, insist on a Manual J load calculation; conversions can need duct resizing or an electrical upgrade.
When is replacing an old heat pump better than repairing it?: If it's past 12–15 years, still uses phased-out R-410A refrigerant, needs a compressor, or the repair bill approaches a third of replacement cost, replacing usually wins. A reputable contractor compares both paths before recommending.
How to tell when a Madison heat pump should be replaced rather than repaired?: Replace when repeated failures, frequent refrigerant leaks, or poor efficiency persist despite repairs. Older units subject to freeze-thaw damage often cost more to maintain. Request an inspection report comparing repair costs, remaining lifespan, and expected performance improvements.
Do Madison permits and inspections commonly delay final system commissioning?: They can. Permit approval and municipal inspections sometimes add days to completion, especially during busy seasons. Use a licensed, bonded installer who handles permits to minimize administrative delays and coordinate final commissioning with the city inspector.
Is dual-fuel integration common for Madison homes with existing gas furnaces?: Dual-fuel setups are available and useful when a backup gas furnace is desired for extreme cold. Look for installers who can program seamless switching between heat pump and furnace and who provide control strategies tailored to Madison's temperature swings.
How do I get a quote from these heat pump installation companies?: Submit one request on this page and we send it to the vetted heat pump installation pros in Madison, WI listed here. They send quotes back — no obligation.