Best Heat Pump Replacement Companies in Yakima, WA
Heat Pump Replacement in Yakima: sizing + authorization
A replacement or conversion is bid on Manual J load calculation, manufacturer authorization, and matched-system commissioning — oversizing is the #1 cause of comfort complaints. Here is what each of the 4 contractors below publishes: In Washington, HVAC contractors hold an L&I HVAC/R Specialty Contractor license — verify on lni.wa.gov before scheduling.
Top picks
Consistently strong customer feedback (4.9★ from 2,655+ Google reviews).
Google 4.9★ (2,655+)
Consistently strong customer feedback (4.8★ from 720+ Google reviews).
Google 4.8★ (720+)
Consistently strong customer feedback (4.9★ from 50+ Google reviews).
Google 4.9★ (50+)
Other Yakima HEAT_PUMP_INSTALL providers
These HEAT_PUMP_INSTALL providers serve the area but didn't surface a category award or ≥2 verified heat pump replacement signals. Confirm credentials and pricing by phone.
Typical Heat Pump Replacement costs in Yakima, WA (2026)
Last updated
Estimated ranges for Yakima, WA. Actual cost varies with home size, equipment, and scope — always request a written quote for your job.
| Service | Typical range |
|---|---|
| Ducted air-source heat pump + air handler, full system (installed) | $7,550–$15,050 |
| Air handler replacement (paired with heat pump) | $1,400–$3,300 |
| Ductwork modification (resize / re-balance per Manual D) | $565–$2,050 |
How Yakima's climate shapes Heat Pump Installation choices in Yakima, Washington
Yakima's hot, dry summers and cold winters raise performance and efficiency expectations for heat pumps and drive seasonal demand for installs and tune-ups. Choosing the best heat pump installation companies in Yakima, WA requires checking licensing, warranties, and availability during peak summer and winter demand.
What Yakima homeowners ask about Heat Pump Installation — and one nearby-area service note
- Can I replace my gas furnace with a heat pump?
- Yes — a heat pump both heats and cools, so it can fully replace a gas furnace. In colder areas a dual-fuel setup keeps the furnace as backup for the coldest days. Either way, insist on a Manual J load calculation; conversions can need duct resizing or an electrical upgrade.
- When is replacing an old heat pump better than repairing it?
- If it's past 12–15 years, still uses phased-out R-410A refrigerant, needs a compressor, or the repair bill approaches a third of replacement cost, replacing usually wins. A reputable contractor compares both paths before recommending.
- Do Yakima contractors need a city or state permit for heat pump replacement?
- Yes. Contractors must follow Washington State contractor registration and L&I licensing rules for mechanical work. Permit requirements and inspections depend on the scope of replacement and local building department rules.
- What warranty and post-installation support should Yakima homeowners request?
- Request manufacturer warranty details and a clear installer warranty (advertised). Confirm who handles warranty registration and whether maintenance plans or commissioning reports are included with the install.
- How should a heat pump be sized for Yakima's hot summers and cold winters?
- Proper sizing uses a room-by-room load calculation that accounts for cooling loads in hot, dry summers and heating needs in cold snaps. Ask for a Manual J or equivalent calculation before signing a contract.
- How do I get a quote from these heat pump installation companies?
- Submit one request on this page and we send it to the vetted heat pump installation pros in Yakima, WA listed here. They send quotes back — no obligation.