Best Heat Pump Replacement Companies in Murray, UT
Heat Pump Replacement in Murray: sizing + authorization
A replacement or conversion is bid on Manual J load calculation, manufacturer authorization, and matched-system commissioning — oversizing is the #1 cause of comfort complaints. Here is what each of the 2 contractors below publishes: Verify your state's HVAC contractor license through the state licensing board before paying a deposit.
Top picks
Consistently strong customer feedback (4.7★ from 7,110+ Google reviews).
Google 4.7★ (7,110+)
Consistently strong customer feedback (4.8★ from 490+ Google reviews).
Google 4.8★ (490+)
Typical Heat Pump Replacement costs in Murray, UT (2026)
Last updated
Estimated ranges for Murray, UT. Actual cost varies with home size, equipment, and scope — always request a written quote for your job.
| Service | Typical range |
|---|---|
| Ducted air-source heat pump + air handler, full system (installed) | $7,200–$14,400 |
| Air handler replacement (paired with heat pump) | $1,350–$3,150 |
| Ductwork modification (resize / re-balance per Manual D) | $540–$2,000 |
Why Murray, Utah homeowners should rethink "Heat Pump Installation" after a cold-snap
A sudden cold-snap in Murray, UT exposes weaknesses in older ductwork and undersized units, leaving homes colder and bills higher. best heat pump installation companies in murray ut should be evaluated for low-temperature performance, warranty terms, and emergency service availability before winter returns.
What Murray homeowners ask most about "Heat Pump Installation" — quick, city-specific answers
- Can I replace my gas furnace with a heat pump?
- Yes — a heat pump both heats and cools, so it can fully replace a gas furnace. In colder areas a dual-fuel setup keeps the furnace as backup for the coldest days. Either way, insist on a Manual J load calculation; conversions can need duct resizing or an electrical upgrade.
- When is replacing an old heat pump better than repairing it?
- If it's past 12–15 years, still uses phased-out R-410A refrigerant, needs a compressor, or the repair bill approaches a third of replacement cost, replacing usually wins. A reputable contractor compares both paths before recommending.
- How should a homeowner prepare a Murray property before a cold-weather heat pump replacement?
- Prepare by clearing outdoor units, ensuring safe access to utility panels, and noting any supplemental heating sources. Share recent service records and describe issues experienced during cold snaps. If the house has older ductwork, mention known leaks or poor airflow. These details help installers size the replacement correctly and plan for duct sealing or accessory electric heat if needed.
- What diagnostic checks should be included in a Murray heat pump pre‑installation inspection?
- Required checks include a load calculation, refrigerant-system pressure test, control and thermostat verification, and duct leakage assessment. Installers should measure static pressure, inspect indoor coil capacity versus design loads, and evaluate supplemental heat integration. Document these checks in the written estimate so homeowners can compare scope and recommended corrective measures across bids.
- How should a homeowner compare bids for heat pump replacement in Murray to avoid undersizing for cold snaps?
- Compare bids by checking the reported Manual J load calculation, listed equipment low‑temperature performance, and any recommended ductwork repairs. Prefer bids that show calculations, refrigerant line sizing, and a plan for cold-weather performance. Avoid choosing solely on lowest price; a complete scope that addresses sizing and duct sealing reduces the risk of poor cold-snap performance.
- How do I get a quote from these heat pump installation companies?
- Submit one request on this page and we send it to the vetted heat pump installation pros in Murray, UT listed here. They send quotes back — no obligation.